To protect your health and others, it is very important to follow these instructions for use.

HOW TO WEAR THE MASK?

Before wearing :
Before touching the mask, wash your hands with soap and water or an alcohol-based solution.
Inspect the mask and make sure there is no holes, tears or damage.
It is recommended to wear the mask on bare skin, avoiding contact with the hair.
Never modify the mask in any way.

How to fit :
Hold the mask by the elastic straps.
Place it at the level of your mouth.
Pass the elastic straps behind the ears.
Adjust the mask to cover the nose, mouth and chin.

When you wear it :
Avoid touching and moving it.
Never put on standby on the forehead or on the chin.

When to change the mask :
When you want to eat or drink.
When it becomes difficult to breathe.
If the mask gets wet.
If the mask is damaged.
If the mask is distorted and no longer fits properly against your face.

When remove it :
Wash your hands with soap and water or an alcohol-based solution.
Unhook the elastic straps to take off the mask of your face.
If the mask is deformed or worn, throw it away in a sealed bin.
At the end : Wash your hands with soap and water or an alcohol-based solution.

HOW TO MAINTAIN THE MASK?
Before opening :
Store the mask in its original protective packaging, in a dry place and out of direct sunlight. Keep it in a dry place with maximum humidity 75% and at a temperature between -2 ° C and + 55 ° C in order to preserve all its characteristics.
No washable !
Single use

WARNING
Filtering half mask shall not be used for more than one shift -Are not suitable for children under 3 years
Always check that the mask is correctly fitted and covers your nose, mouth and chin. It is recommended that this mask be worn on bare skin; facial hair can reduce the filtration efficiency of the face covering.
This filtering half mask is manufactured for COVID-19 protection only. As requested by World Health Organization recommendations, for this specific use, the nominal protection factor given by this filtering half mask is the same than the FFP2 nominal protection factor defined in EN 149:2001+A1:2009. This filtering half mask is not a filtering half mask for general use and shall not be used for purposes other than protection against COVID-19.
Despite all the care taken in the manufacture of these masks, responsibility to ensure the adequacy of the mask with the characteristics of the environment of use belongs to the sole user, and in no case to the manufacturer or supplier. Entire recommendations and methods of use described above should be followed strictly.